To design a firewood processor

I will be posting drawings as I design this unit and your comments would be greatly  appreciated go to the Message board to leave your comments
1 in by 1 inch blade guides bolted to tube frame bolts not shown yet
Curved blade will help to center log
4 inch cylinder 18500 pounds push @ 1500 psi, I figure a pump putting out 12 GPM will put the cycle time in the 11 second range
Disclaimer: plans on this site are not certified by an engineer or safety tested. Sawmillplans.com is not responsible for losses or damages as a result of building these projects. Usage of this site is an acknowledgement of this notice.
BUILD AT YOUR OWN RISK
Copyright 2008 SAWMILLPLANS.COM All Rights Reserved
Contact: warznorth@yahoo.com with questions or comments.
Website: www.sawmillplans.com www.builditpplans.com
Click here to go to Slotland!
Loading...